Alternative Speed Bump Uses - Cable Protection

 Have you ever needed to run a cable or hose across a driveway or gateway, but have not wanted to dig a trench, re-tarmac or disturb paving stones?

When faced with this dilemma usually the only option would be to run the cable or hose overhead, but even this is not always practical and can be very unsightly. 

Our speed bumps offer a solution for this problem by allowing you to run the cable within a groove in the underside of the speed bump. Meaning your cable can run across even high traffic areas without you having to worry about it becoming crushed and damaged as it is fully protected by the speed bump above. 

Over the years we have run various cables and hoses under our speed bumps, including CCTV cables, water hoses for irrigation systems and power cables to supply outbuildings. Saving a lot of the cost that is normally associated with digging and re-tarmacking. It also causes little to no disruption whilst being installed with the average speed bump being installed in less than an hour. 

Take a look at our range of speed bump components and speed bump kits for more information and prices.


Back to blog